mopwind.blogg.se

• LSI MEGARAID STORAGE MANAGER DEFAULT PASSWORD SOFTWARE

The red dot icon ( ) indicates a Shield state If any of the diagnostics tests fail, the physical drive will transition to BAD state (FAILED or UNCONF BAD). The three possible Shield states are Unconfigured - Shielded, Configured - Shielded, and Hotspare - Shielded (which is not used in the d3 application).įollow these steps to view the Shield state under the Physical view tab:Ĭlick the Physical tab in the device tree If firmware detects a problem or a communication loss for a physical drive, it transitions the physical drive to a bad (FAILED/UNCONF BAD) state. To avoid transient failures, an interim state called the Shield state appears before marking the physical drive as bad state. The results of the diagnostic tests determine if the physical drive is good or bad. Physical devices in MegaRAID firmware transit between different states. You can view the properties for individual drives from the drop down menus, as follows: The following figure shows the Logical view The Logical view shows the hierarchy of controllers, virtual drives, and the drives and drive groups that make up the virtual drives. The properties for these components appear in the right panel At the top of the hierarchy is the system itself, followed by the controller and the backplane. The controller label identifies the MegaRAID controller, such as the MegaRAID SAS 9260-8i controller, so that you can easily differentiate between multiple controllers. Each controller has one or more ports. Drives and other devices are attached to the ports. The properties for each item appear in the right panel of the screen.

The Physical view shows the hierarchy of physical devices in the system. This will open MegaRAID storage Manager - Host View window, as follows:Ĭlicking on Configure Host will open the main Dashboard View:  Red: The server storage configuration has failedĮnter d3 as the User Name and click Login.

 Orange: The server is running in a degraded state  Yellow: The server is running in a partially degraded state (possibly because a drive in a virtual drive has failed)  Green: The server is operating properly The servers are colour-coded with the following definitions:

LSI MEGARAID STORAGE MANAGER DEFAULT PASSWORD SOFTWARE

The Host View dialog shows an icon for each server on which the MegaRAID Storage Manager software is installed. To start the MegaRAID Storage Manager software double-click on the desktop icon. You must have administrative privileges to use the MegaRAID Storage Manager software in either full-access or in view-only mode. The wizard allows you to easily create new storage configurations and modify configurations. The Configuration wizard greatly simplifies the process of creating drive groups and virtual drives.

The MegaRAID Storage Manager software enables you to easily configure the controllers, drives, and virtual drives on your disguise server. The MegaRAID Storage Manager software enables you to configure, monitor, and maintain storage configurations on LSI SAS controllers such as those installed in your disguise system. There is no content backup provided by Raid0. Please Note: disguise uses Raid0 to provide faster streaming access to content.